Last additions
ost-040.jpg
145 viewsJun 28, 2016
intake_short_radius_4_and_3-vert.jpg
156 viewsJun 28, 2016
circuit_motor_removed~1.jpg
Step 09: tacho circuit and motor unit351 viewsonce you removed the five screws you can remove the unit for the conversionJun 22, 2016
unsoldered_R2.jpg
Step 12: resistor R2 (15k Ohm) partialy desoldered330 viewsresistor R2 (15k Ohm) partialy desolderedJun 22, 2016
solder_points_R2.jpg
Step 11: solder points of resistor R2 (15k Ohm)331 viewsdesolder resistor R2, locking pliers are one way to pull the resistor leg loose once the solder point is softenedJun 22, 2016
screws5.jpg
Step 08: screws (5) holding the circuit and motor in place324 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016
resistor_R2.jpg
Step 10: resistor R2 (15k Ohm)336 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016
circuit_motor.jpg
Step 07: circuit and motor revealed321 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
screws4.jpg
Step 04: fascia screws (4)327 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
needles.jpg
Step 03: tacho and speedo needle322 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
light_guides.jpg
Step 06: light distributors314 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
fascia_OEM.jpg
Step 05: fascia panels314 viewsremove the two fascia panelsJun 22, 2016
tabs_top3.jpg
Step 01: retaining tabs top (3)297 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent coverJun 22, 2016
tabs_bottom3.jpg
Step 02: retaining tabs bottom (3)295 viewspush down on the 3 retaining tabs on the bottom (best start on the side) to remove the transparent coverJun 22, 2016
20160621_220946.mp4
Conversion test successful327 views10.44kOhm instead of 15kOhmJun 21, 2016
3597 files on 240 page(s) 180