 Last additions |
269 viewsJul 05, 2016
|
|
245 viewsJul 01, 2016
|
|
244 viewsJun 30, 2016
|
|
268 viewsJun 28, 2016
|
|
240 viewsJun 28, 2016
|
|
245 viewsJun 28, 2016
|
|
Step 09: tacho circuit and motor unit485 viewsonce you removed the five screws you can remove the unit for the conversionJun 22, 2016
|
|
Step 12: resistor R2 (15k Ohm) partialy desoldered473 viewsresistor R2 (15k Ohm) partialy desolderedJun 22, 2016
|
|
Step 11: solder points of resistor R2 (15k Ohm)486 viewsdesolder resistor R2, locking pliers are one way to pull the resistor leg loose once the solder point is softenedJun 22, 2016
|
|
Step 08: screws (5) holding the circuit and motor in place470 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016
|
|
Step 10: resistor R2 (15k Ohm)468 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016
|
|
Step 07: circuit and motor revealed453 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
|
|
Step 04: fascia screws (4)451 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
|
|
Step 03: tacho and speedo needle474 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
|
|
Step 06: light distributors448 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
|
|
| 4006 files on 268 page(s) |
 |
|
|
|
|
|
207 | |
|
|
|
|
|
|
