Last additions - OST Porting Services

Last additions

Step 08: screws (5) holding the circuit and motor in place724 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016

Step 10: resistor R2 (15k Ohm)711 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016

Step 07: circuit and motor revealed701 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016

Step 04: fascia screws (4)721 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016

Step 03: tacho and speedo needle684 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016

Step 06: light distributors694 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016

Step 05: fascia panels695 viewsremove the two fascia panelsJun 22, 2016

Step 01: retaining tabs top (3)679 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent coverJun 22, 2016

Step 02: retaining tabs bottom (3)620 viewspush down on the 3 retaining tabs on the bottom (best start on the side) to remove the transparent coverJun 22, 2016