 Last additions - User galleries |
368 viewsNov 21, 2016
|
|
390 viewsJul 28, 2016
|
|
395 viewsJul 11, 2016
|
|
365 viewsJul 11, 2016
|
|
Step 09: tacho circuit and motor unit372 viewsonce you removed the five screws you can remove the unit for the conversionJun 22, 2016
|
|
Step 12: resistor R2 (15k Ohm) partialy desoldered354 viewsresistor R2 (15k Ohm) partialy desolderedJun 22, 2016
|
|
Step 11: solder points of resistor R2 (15k Ohm)360 viewsdesolder resistor R2, locking pliers are one way to pull the resistor leg loose once the solder point is softenedJun 22, 2016
|
|
Step 08: screws (5) holding the circuit and motor in place347 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016
|
|
Step 10: resistor R2 (15k Ohm)353 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016
|
|
Step 07: circuit and motor revealed346 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
|
|
Step 04: fascia screws (4)347 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
|
|
Step 03: tacho and speedo needle345 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
|
|
Step 06: light distributors330 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
|
|
Step 05: fascia panels335 viewsremove the two fascia panelsJun 22, 2016
|
|
Step 01: retaining tabs top (3)315 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent coverJun 22, 2016
|
|
| 502 files on 34 page(s) |
 |
|
|
|
|
|
|
|
29 | |
|
|
|
|
