 Last additions - User galleries |
Step 08: screws (5) holding the circuit and motor in place404 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016
|
|
Step 10: resistor R2 (15k Ohm)403 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016
|
|
Step 07: circuit and motor revealed398 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
|
|
Step 04: fascia screws (4)392 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
|
|
Step 03: tacho and speedo needle401 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
|
|
Step 06: light distributors380 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
|
|
Step 05: fascia panels387 viewsremove the two fascia panelsJun 22, 2016
|
|
Step 01: retaining tabs top (3)365 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent coverJun 22, 2016
|
|
Step 02: retaining tabs bottom (3)363 viewspush down on the 3 retaining tabs on the bottom (best start on the side) to remove the transparent coverJun 22, 2016
|
|
Conversion test successful399 views10.44kOhm instead of 15kOhmJun 21, 2016
|
|
AE86 custom 10krpm fascia with ECON/PWR light option377 viewsCustom 10krpm fascia with ECON/PWR light option for OEM cluster.Jun 09, 2016
|
|
Water/Oil cutout dimensions382 viewsWidth 79.7mm; Height 15.7mmJun 09, 2016
|
|
230 viewsJun 01, 2016
|
|
251 viewsMar 31, 2016
|
|
rpm simulation on OEM cluster326 viewsFeb 17, 2016
|
|
| 525 files on 35 page(s) |
 |
|
|
|
|
|
|
|
|
31 | |
|
|
|
